Angel Crafts - How to make a Safety Pin Angel Ornament - How To make wings - insert a piece of wire through the top of the attached pins in the back.
How To Make a Safety Pin Angel
~Safety Pin Angel~Posted By "Angel Wings"
Date 2001/10/14 151 p.m.
Wanted to share my safety pin angel The lights were out all yesterday... until early this morning. So I worked on coming up with an angel pin.
Directions
String beads and pearls on pins as shown.
Use large safety pins.
To connect;
Make a halo from gold wire.
Be sure and leave a long end on it.
Insert the wire in the bead for head and the clear bow.
After you have done this go through the end of the three safety pins to attach.
Finish off by going back through the pins and tying off.
Bottom of angel Use a peice of wire and attach the end to safety pin.
String two pearls on wire to seperate pins and go through the pin head and string two more pearls.
Tie off by wrapping wire several times around pin head.
Wings:
To make wings insert a piece of wire through the top of the attached pins in the back.
String 24 seed pearls onto each side of wire and twist to finish off...securing beads in place.
Bend wings to look pretty and glue pin to the angel back. You are done.
Hope you like her.
~Angel Wings~